Tool and Test Equipment Requirements (Sec. III)

TM 11-6130-377-14

specifies by code, those common tool sets (not

subassemblies, and modules for which maintenance is

individual tools) and special tools, test, and support

authorized.

equipment required to perform the designated function.

c. Column X, Maintenance Functions. Column 3

lists the functions to be performed on the item listed in

f. Column 6, Remarks. Column 6 contains an

column 2. When items are listed without maintenance

alphabetic code which leads to the remark in section IV,

functions, it is solely for purpose of having the group

Remarks, which is pertinent to the item opposite the

numbers in the MAC and RPSTL coincide.

particular code.

d. Column 4, Maintenance Category. Column 4

C-4.

Tool and Test Equipment Requirements

specifies, by the listing of a "worktime" figure in the

appropriate subcolumn(s), the lowest level of

(Sect. III)

maintenance authorized to perform the function listed in

a. Tool or Test Equipment Reference Code. The

column 3. This figure represents the active time

numbers in this column coincide with the numbers used

required to perform that maintenance function at the

in the tools and equipment column of the MAC. The

indicated category of maintenance. If the number or

numbers indicate the applicable tool or test equipment

complexity of the tasks within the listed maintenance

for the maintenance functions.

function vary at different maintenance categories,

b. Maintenance Category.

The codes in this

appropriate "worktime" figures will be shown for each

column indicate the maintenance category allocated the

category. The number of task-hours specified by the

tool or test equipment.

"worktime" figure represents the average time required

c. Nomenclature. This column lists the noun name

to restore an item (assembly, subassembly, component,

and nomenclature of the tools and test equipment

module, end item or system) to a serviceable condition

required to perform the maintenance functions.

under typical field operating conditions. This time

d. National/NATO Stock Number. This column

includes preparation time, troubleshooting time, and

lists the National/NATO stock number of the specific

quality assurance/quality control time in addition to the

tool or test equipment.

time required to perform the specific tasks identified for

e. Tool Number.

This column lists the

the maintenance functions authorized in the

manufacturer's part number of the tool followed by the

maintenance allocation chart. Subcolumns of column 4

Federal Supply Code for manufacturers (5-digit) in

are as follows:

parentheses.

C-Operator/Crew

O-Organizational

C-5.

Remarks (Sect. IV)

F-Direct Support

H-General Support

a. Reference Code. Not applicable.

D-Depot

b. Remarks. Not applicable.

e. Column 5, Tools and Equipment.

Column 5

(Next printed page is C-3)

C-2