|
| |
- OPERATOR, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
- Table of Contents
- Table of Contents
- Chapter 1. INTRODUCTION
- Figure 1-1. Inverter, Power, Static PP-7078/U and master/slave cable assembly.
- Section II. DESCRIPTION AND DATA
- System Application
- Items Comprising an Operable Equipment
- Chapter 2. INSTALLATION
- Section I. SERVICE UPON RECEIPT OF MATERIEL
- Figure 2-1. Front panel open, parts location, 1973 model.
- Figure 2-1.1. Front panel open, parts location, 1974 model.
- Figure 2-2. Installation wiring diagram for single and dual operation.
- Preparation for Reshipment
- Chapter 3. OPERATING INSTRUCTIONS
- Figure 3-1. Controls and indicators.
- Operating Procedures
- Chapter 4. OPERATOR AND ORGANIZATIONAL MAINTENANCE
- Weekly Preventive Maintenance Checks and Services Chart
- Section III. ORGANIZATIONAL MAINTENANCE
- Fuse Replacement (1973 Model Only)
- Chapter 5. FUNCTIONING OF EQUIPMENT
- Figure 5-1. System block diagram.
- System Description of Inverter
- System Description of Inverter - continued
- Figure 5-2. Inverter drive A1A2 overall block diagram, 1973 model.
- Functional Description of Inverter Drive Circuit Board A1A2 (1974 Model Only)
- Oscillator Circuit
- Shunt Trip Relay Driver
- Figure 5-2.1. Inverter drive A1A2 overall block figure diagram, 1974 model.
- Power Supply Circuit.
- Quarter-Start Generator.
- Chapter 6. GENERAL SUPPORT MAINTENANCE
- Operating Inverter with Front Panel Open
- Inverter Troubleshooting Chart.
- Inverter Troubleshooting Chart - continued
- Figure 6-1(1). Component locations, 1973 model (sheet 1 of 3).
- Figure 6-1(2). Component locations (sheet 2 of 3).
- Figure 6-1(3). Component locations (sheet 3 of 3).
- Figure 6-1.1(1). Component locations, 1974 model (sheet 1 of 3).
- Figure 6-1.1(2). Component locations, 1974 model (sheet 2 of 5).
- Figure 6-1.1(3). Component locations, 1974 model (sheet 3 of 3).
- Section III. REPAIRS
- Inverter Repairs
- Inverter Repairs - continued
- Inverter Drive Circuit Board A1A2 Testing and Repair
- Failure Isolation and Repair
- DC Circuit Breaker A1CB1
- AC Circuit Breaker A1CB2
- ELAPSED TIME Meter A1M5
- Cooling Fan Removal and Replacement
- Heat Sink Duct Mounted Fan
- Section IV. VERIFICATION AND ADJUSTMENT
- Low Voltage Fault Adjustment
- High Voltage Fault Adjustment
- Appendix A. REFERENCES
- Appendix C. MAINTENANCE ALLOCATION
- Tool and Test Equipment Requirements (Sec. III)
- SECTION II MAINTENANCE ALLOCATION CHART
- SECTION II MAINTENANCE ALLOCATION CHART - continued
- INDEX
- Figure FO-1. Inverter, Power, Static PP-7078/U (Deltec Model DI-5003-259), schematic diagram.
- Figure FO-1.1. Inverter, Power, Static PP-7078/U schematic diagram, 1974 model.
- Figure FO-2. Inverter Drive A12, schematic diagram.
- Figure FO 2-1. Inverter drive A1A2, schematic diagram, 1974 model.
- Figure FO-3. Inverter drive circuit board A1A2, component locations.
- Figure FO-3.1. Inverter drive circuit board A1A2, component locations 1974 model.
- The Metric System and Equivalents
- TM-11-6130-377-14
- Shared Top Border
- Shared Bottom Border
- Blank Page
- DISTRIBUTION
- RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
- Shared Left Border
|
Click
here for thousands of PDF manuals