Location of Repair Parts

TM 11-6125-238-12 Operator and Organizational

or basic quantity by which the listed item is used in

Maintenance Manual: In-

performing the actual maintenance function. This

measure is expressed by a two-character alphabeti-

verter, Vibrator PP-1703/U.

cal abbreviation; e.g., ea, in, pr, etc, and is the basis

1-5. Location of Repair Parts

used to indicate quantities and allowances in

subsequent columns. When the unit of measure

a This manual contains one cross-reference

differs from the unit of issue, the lowest unit of issue

index (sec V) to be used to locate a repair Part when

that will satisfy the required units of measure will&

either the Federal stock number or r e f e r e n c e

requisitioned

number (manufacturer's part number) is known.

e. Quantity Incorporated in Unit. This column

The first column in the index is prepared in

indicates the quantity of the item used in the

numerical or alphanumeric sequence in ascending

equipment.

order. The reference numbers (manufacturer's part

f. 15-Day Organizational Maintenance Allowance.

numbers) are listed immediately following the Iast

(1) The repair parts indicated by an asterisk in

listed Federal stock number in the index of Federal

the allowance column represent those authorized for

stock numbers

use at the organizational category, and will be

b. When the Federal stock number or reference

requisitioned on an "as required" basis, until

number is known, follow the procedures given in (1)

stockage is based on demand in accordance with AR

and (2) below.

710-2.

(1) Refer to the index of Federal stock numbers

(2) Major Army commanders are authorized to

(see V) and locate the Federal stock number or

approve reduction in the range of support items

reference number. The FSN and reference number

authorized for use in units within their commands.

are cross-referenced to the applicable figure and

Recommendations for increase in range of items

item number or reference designation.

authorized for use will be forwarded to Commander,

(2) Refer to the repair parts list (see III) and

US Army Electronics Command, ATTN: AMSEL-

locate the figure number (col 7a) and item number or

MA-TMDE, Fort Monmouth, NJ., 07703. Any

reference designation (CO1 7b) as noted in the FSN

changes approved will be reflected in a revision to

index

the RPSTL.

c. When the figure and item number or reference

(3) Allowance quantities are indicated in the

designation are known, scrutinize columns 7a and ?b

special tools list section for special tools, TMDE, and

of the repair parts list (see III) until the item is

other equipment.

located.

g. Illustration. This column is divided as follows:

d. When the FSN, reference number, figure

(1) Figure number. Indicates the figure number

number, item number and reference designation are

of the illustration on which the item is shown in TM

not known, scrutinize column 3 of the repair parts list

11-6125-238-12.

(see III), which is arranged in alphabetical order.

(2) Item number. Indicates the item number or

1-6. Abbreviations

reference designation used to reference the item in

Not applicable.

the illustration.

1-7. Reporting of Equipment Publication

1-4. Special Information

Improvements

a. Usable on codes are included in column 3.

The reporting of errors, omissions, and recommenda-

Uncoded items are applicable to all models. Identifi-

tions for improving this publication by the individual

cation of the usable on codes used in this publication

user is encouraged. Reports should be submitted on

are --

DA Form 2028 (Recommended Changes to Publica-

Used on

Code

tions and Blank Forms) and forwarded direct to

PP-1703/U

A7D

Commander, US Army Electronics Command,

ATTN: AMSEL-MA-TMDE, Fort Monmouth, NJ,

b. The following publication pertains to the

07703.

PP-1703/U and its components:

(Next printed page is