4-11. MAINTENANCE INSTRUCTIONS - Continued
Minor damage to finishes,
such as small scratches,
require touchup painting
to the affected areas only.
l Remove all rust and corrosion by lightly
sanding the affected areas with fine
sandpaper (item 7, Appendix E).
l Clean with solvent and abrasive and
(item 3, Appendix E) and allow to dry.
l Brush two (2) coats of paint (item 6,
Appendix E) on the bare metal to
protect it from further corrosion.
To remove indicator lamp:
Unscrew indicator lens.
Pull lamp straight out from lens.
Push in serviceable lamp and
OFF- Indicator lamp should be lighted.
Using screwdriver, or fingers, loosen
Lift converter out of rack.
Replace converter with serviceable
equipment. Perform procedures in Section
II of this chapter whenever equipment is
installed or reinstalled.